Make Your Own Jewelry Organizer

Make Your Own Jewelry Organizer

I love to wear jewelry. I have the cutest little jewelry organizer that I keep in my closet, but I really needed something by my bathroom sink where I take my jewelry off each night. I’m always afraid that something will fall down the drain or my earrings will rust if they get wet – I never said I wore expensive jewelry 🙂

I thought about buying a little shelf to keep by the sink, but then I saw one at a store and thought, “Hey! I can make that!” So, I did. The one in the store costs $25, mine was less than $10. And it’s so much cuter than anything store bought.

Here’s how I made my own jewelry organizer:
Materials:
*Drawer divider (mine came from Walmart and was made out of bamboo)
*12×12 piece of scrapbook paper
*Acrylic craft paint (only if you choose to paint it, you might just want to keep it the wood color)
*Mod Podge (You don’t have to use this. You can use any glue. I used Mod Podge because it works great as a glue and a sealer)
*Screw eyes (These are little screws with a loop at the end.)
*Picture hanger
*Nail, hammer, and a vice-grip
*Optional – trim, felt

Before

I painted my drawer organizer a soft yellow color. I had to give it two coats. It only took about an hour to dry so I was able to move on to the next step fairly quickly – the scrapbook paper. I simply measured each opening and cut the paper to that size. I then put a thin layer of Mod Podge in each compartment (working on just one at a time) and then put in the paper. You don’t want to use too much Mod Podge, or any glue, because it can make the paper bubble. Mine still bubbled a little bit but it’s not noticeable unless you know it’s there. I put in half the sheet of paper, smoothed it down, and then laid the rest in. That seemed to make it easier. After I put in each piece I put a thin layer of Mod Podge over all the paper to seal it and help insure it doesn’t get torn sometime in the future. I let mine dry over night.

Then it was time to use the little screw eyes. I bought mine at a home improvement store in the hardware section. I had never used these little guys before and had no idea how to put them in. I ended up using a nail, which I held with a vice grip, and hammered in just a little bit to make a small hole. Then I used the vice grips to hold on to the screw eyes and I just screwed it in. Very easy process. Just be careful, the end of each screw came through the underside of the wood a little bit. Make sure it doesn’t scratch whatever surface you’re working on, or even yourself when you pick it up.

The last step is to nail the picture hanger to the back of the jewelry organizer. Viola! You now have the cutest jewelry organizer to hang on your wall! Here is a picture of my finished product.

After

Oh, one more thing. I had some extra ribbon with adhesive on the back, and I used it to trim mine out a little bit. I also added a little strip of felt to the bottom shelf so my watch wouldn’t slip off easily or get scratched. Super easy, super cute, super cheap!

*Another great tip – you don’t have to leave this upright! You can turn it side ways or even upside down! You can also use the top of it as a shelf to keep perfumes or face creams or whatever else you can think of!

What ideas do you have for this jewelry organizer? What other things could you use it for?

One Response »

  1. This is such a cute idea! I could make one for my earings and necklaces and a matching one for my hair care products such as moose, hairspray, silk drops… Awesome idea!!!
    Thank you for sharing it!

    Hollie

Leave a Reply

Your email address will not be published.